RSS
 

Archive for the ‘Parts’ Category

PARTS – transaxle nosecone

24 Aug

Today I received a transaxle nosecone to replace the broken one.  Got it from nice guy named Greg on The Samba.Com for $15 plus shipping. Not bad. Knock off the crud and I’ll think it’ll clean up nicely.

 
 

PARTS – Fasteners

07 Jul

New, stainless steel fasteners have arrived from England.

I wanted to upgrade the fasteners holding the chassis to the body, so I picked up a set from a gentleman on eBay (Member id: dcmotorsportuk). Some people sell these kits and include the rectangular mounting brackets, but I decided to keep my originals, and just clean them. The bolts could be cleaned too, I suppose, but some of the broke anyway when I was taking them out; I think the stainless will give me a longer-lasting, rust-resistant fastener.

Also, the engine tin bolts just seem to deform when you take them out. Straight-slot heads are tough when they get rusted. So I also picked up a set of engine tin fasteners from the same eBay seller.

 
No Comments

Posted in Parts

 

PARTS – Floor Pans

02 Apr

Received new floor pans today. I ordered these from a supplier on eBay (eBay ID: CarParts) for $62.55 each, shipping included. Jack points and cross braces are included, and are welded-on. Seat brackets are also included.

The price was quite low, so my expectations were, too. Shortly after paying for them, I noticed that eBay had marked their userID as “No longer a registered user”. CarParts had a feedback rating of about 37000, so they were selling a lot of stuff. Perhaps they had some billing issues? Not sure. I was a little worried, and sent some messages to the website (carparts.com) and found out the pans had already shipped. That was a relief. Pans showed up a day or two later.

Pans are made in Brazil. They look OK. I’ve never installed floor pans before, so I have no idea how they should look/feel. Will know more when I put them in. Everyone talks about the thickness of the metal, so I put the caliper on it — .061 or thereabouts. According to this UNC web page that works out to 16 gauge metal. Other sites, users, and suppliers refer to 18 gauge metal for floor pans, so maybe that’s what these are. I’m not sure how much thickness is added by the paint, and how that affects the gauge.

I cut my hand pulling the pan out of the box — the sheet metal is sharp. I hope that’s not one of those lessons that take a lot of ‘experience’ to learn.

The company still has them on the website (here’s the passenger side: Floor Pan, P/N:113-701 060), albeit at a little higher price ($104.99).

 
 

PARTS – Hubcaps

28 Jul

Received a set of hubcaps today. Original German ‘caps from the sixties, purchased from a nice guy and Samba.com member – Emmett from Florida.

Add $75 to the Bug Bill ™.

 
No Comments

Posted in Parts

 

PARTS – Kick Panels

27 May

Received a couple of kick panels that go under the rear seats. These were from 1963 Bug, and look to be in good condition. Purchased from a member of TheSamba.com website.

Kick panels for the back seat.

Add $40.00 to the Beevis Bill(tm).